Edit (‘Q’) Parameters

This section lists the unchangeable edit (’q‘) parameters in KEPLER that may be edited (but not directly changed) during execution by the “q n” command, e.g.,

q 7
q iter
iter

where N stands for the name or number of the parameters listed below. The mode of these parameters (fixed or floating point) follows the normal FORTRAN convention. They are remembered in the restart dumps and more may readily be added.

Implementation Details

They are located in the general COMMON in include file KEPCOM (starting with dt (q 1)) and their ASCII names and types are listed respectively in the nameqparm and iqtype arrays loaded in data block KEPDAT. They are initialized in subroutine GENER and also (if necessary) subroutine RESTART, e.g., when new parameter are added and an loder version is loaded.

• Parameter List by Number
• Parameter List by Name
• Edit (‘Q’) Parameters by Function
  • Time Step-Related Parameters
  • Zoning-Related Parameters
  • Evolution-Related Parameters
  • Other Surfarce Properties
  • Convergens-Related Parameters
  • APPROX / ISE / NSE Network-Related Parameters
  • Energy Balance Parameters
  • Supernova-Related Parameters
  • Rotation-Related Parameters
  • BURN-Relared Parameters
  • QDump-Related Parameters
  • Mass Loss-Related Parameters
  • Accretion-Related Parameters
  • Decretion-Related Parameters
  • Viscous Energy Deposition
  • Initial Composition Parameters
  • Internal Control Flags
  • Version Control Parameters
  • Cutsurf-Parameters
  • WIMP-Related Parameters
  • X-Ray Burst-related Parameters
• Time-Edit Variables
  • Time-Edit Variable List